User's Manual

Wearing the SR-15 Behind-the-Head Headset
1. Loosen the cable at the headband cord clip on the back of the headband to allow enough slack to move
the speaker away from the earloop.
2. Adjust the nylon band on the adjustment strap so that it lies flat against the headband of the headset.
3. Grasp the headset's ear loops and spread them slightly apart.
4. Place the headset behind your head, and slip the ear loops over your ears.
5. Adjust the headset's speaker so it fits snugly over your ear.
6. Place the microphone at the corner of your mouth; it should be positioned about 1/4" away from your
face.
Blue waves on the microphone face your mouth when the microphone is positioned properly.
7. Clip the headset cord to your shirt or jacket where it is comfortable.
8. Let the cable fall down your back, and clip it to the belt near the device. If you are using a device
cover, we recommend that you clip the bottom clip directly onto the cover.
9. Adjust the nylon adjustment strap on the back of the headband so that it fits firmly, but comfortably,
against the back of your head. The nylon band can be adjusted by sliding the plastic buckle.
10. Connect the headset to the device.
Removing the SR-15 Headset Adjustment Strap
1. Align the keying rib on the plunger with the slot in the barrel.
Figure 72: Keying Rib and Slot
2. Push the plunger all the way down until the plunger top lip contacts the top of the barrel, making
sure the keying rib is inside the keying rib slot.
3. With the plunger pressed all the way in, pull the adjustment strap clip to remove it from the headband.
Figure 73: Removing the Adjustment Strap
Confidential: For informational use by Vocollect Resellers and customers only
104 | Vocollect Hardware Documentation