User's Manual

• If you insert a fully charged battery into a charger, the charger will analyze the battery's status
and then "top off" the battery's charge. During this process, the left LED indicator for that slot
on the charger is red. It may take several minutes for this process to complete, at which time
both LED indicators for that slot turn green.
1. Make sure the battery charger is powered. The green LED indicator on the end of the battery charger
should be lit.
2. Power off the headset by pressing and holding the Plus and Minus buttons on the earpiece for three
seconds and then remove the battery.
3. Hold the battery with its contacts to the bottom and the Vocollect logo facing toward you, and insert
it into an empty slot on the battery charger.
4. Press down on the battery until it snaps into place.
5. Make sure the battery is firmly in place and cannot be removed without pressing the battery release
button.
Inserting a Battery into the SRX Wireless Headset
Important: Do not force the battery into the compartment. Doing so may result in damage to the
battery or the headset. If the battery does not snap easily into place, reposition the battery in the
compartment and try again.
1. Make sure the battery is charged. A battery is fully charged and can be removed from the charger
when the left and right LED indicators for that slot on the charger are green.
2. Hold the headset with the battery compartment facing toward you.
3. Place the end of the battery with the contacts into the compartment first so that the contacts on the
bottom of the battery line up with the contacts in the compartment.
4. Press down on the battery until it snaps into place.
5. Make sure the battery is firmly in place and cannot be removed without pressing the battery release
button.
Removing a Battery from an SRX Wireless Headset
Important: Do not remove the battery until the LED indicator on the headset is off.
1. Power off the headset by pressing and holding the Plus and Minus buttons on the earpiece for three
seconds.
2. Hold the headset with the battery compartment facing toward you.
3. Pull the battery release button, located on the left side of the battery compartment, away from the
battery until the end of the battery pops up from the compartment.
4. Lift the battery out of the compartment.
Battery Warm-Up Time
If a battery has been used in a cold environment, it will not begin charging until it warms up sufficiently.
Approximate warm-up timeTemperature of battery use
6 minutes-4°C (24.8°F)
10 minutes-10°C (14.0°F)
22 minutes-20°C (-4°F)
30 minutes-30°C (-22°F)
Confidential: For informational use by Vocollect Resellers and customers only
116 | Vocollect Hardware Documentation