User's Manual

Removing the SRX2 Electronics Module from a Headband
Important: Do not squeeze the battery latches on the sides of the electronics module while removing
it from the headband. The battery may be inadvertently released from the electronics module.
1. Grasp the SRX2 electronics module with one hand, pressing your thumb and fingertips into the gap
between the electronics module and earpiece hub.
2. With the other hand, hold the headband by the earpiece hub.
3. Pull the electronics module away from the earpiece hub.
SRX2 Compatibility
Vocollect has tested the SRX2 Wireless Headset with the following devices and Vocollect Voice Software
versions. Support and compatibility of the SRX2 headset is not limited to these products, but the customer
assumes risks related to untested configurations.
Vocollect Voice SoftwareDevice
VoiceClient
®
3.8 and newer
VoiceCatalyst
®
1.1 and newer
Vocollect Talkman A500 and Talkman A500 VMT
VoiceClient 3.8 and newerVocollect Talkman T5 and Talkman T5m
VoiceCatalyst MP for Windows XP 1.0 and newerWindows XP PC and other supported display
terminals
VoiceClient MP 2.0 and newerIntermec
®
CK3
VoiceCatalyst MP for Windows XP 1.0 and newerIntermec CV61
VoiceClient MP 2.0 and newerPsion WORKABOUT Pro G2
Psion WORKABOUT Pro (WAP3)
Psion NEO
VoiceClient MP 2.0 and newerMotorola
®
MC9500
Charging the SRX2 Headset
Figure 91: SRX2 Wireless Headset High-Performance Battery
The SRX2 Wireless Headset is powered by a rechargeable lithium ion battery pack.
A fully depleted SRX2 Wireless Headset battery will be fully recharged in less than 6 hours. The headset
user will hear the following warnings when the battery charge is low.
Confidential: For informational use by Vocollect Resellers and customers only
124 | Vocollect Hardware Documentation