User's Manual

• If you insert a fully charged battery into a charger, the charger will analyze the battery's status

and then "top off" the battery's charge. The ring LED indicator light for that port will be yellow

during this process. When complete, the ring LED indicator will turn green.

1. Make sure the battery charger is powered. To power on the charger, connect the power supply to the

charger and a power source. The LED indicator light at the bottom right of the charger face panel

should be solid green.

2. Power off the headset by pressing and holding the Power button on the electronics module for

approximately one second.

3. Remove the battery from the headset electronics module.

4. Hold the battery with the Vocollect logo facing toward you, and push it onto an empty port on the

battery charger until it snaps into place.

Note: See the chart on SRX2 Battery Charger LED Indicators for more information on LED

patterns .

Make sure that the battery is properly mounted on the charger port. The ring LED indicator light

will turn yellow or green when the battery contacts connect to the charger port contacts. If the ring

LED blinks red, the battery is not seated properly. Remove the battery, and mount it on the port

again.

6. When the ring LED indicator turns a solid green, the battery is fully charged. Pull the battery off the

charger port to insert it into an SRX2 headset electronics module.

Inserting a Battery into the SRX2 Wireless Headset

1. Make sure the battery is charged. A battery is fully charged and can be removed from the charger

when the LED ring indicator on the charger port for that battery is green.

2. Position the headset electronics module with the buttons facing toward you.

3. Hold the battery with the label side down and contacts facing the open end of the electronics module

opposite the mic boom.

4. Push the battery onto the electronics module until it clicks in place.

5. Make sure the battery is firmly in place and cannot be removed without pressing the battery release

latches.

Removing a Battery from an SRX2 Wireless Headset

Important: Do not remove the battery from the SRX2 headset until the LED indicator on the

headset is off.

Confidential: For informational use by Vocollect Resellers and customers only

126 | Vocollect Hardware Documentation