User's Manual

1. Reboot the Talkman device or remove it from a charger to initiate a scan for headsets.
2. Turn on the headset.
The headset will remain in pairing mode for ten minutes. If not paired within ten minutes, it powers
off.
3. Hold the headset and Talkman device so they are within six inches of each other but not touching.
The blue LED indicator on the Talkman device turns on, may flash a few times, and then remains
lit. After 20 to 30 seconds, the headset beeps three ascending tones and its LED indicator flashes
blue. These indicators confirm that a pairing has completed.
4. Put on the headset. You will hear the headset repeat the serial number of the Talkman device to
which it is paired.
5. Verify that the number matches the serial number on the Talkman device.
If you need to attempt the pairing again, re-enter pairing mode by pressing and releasing the Plus
(+) and Minus (-) buttons on the headset control panel.
6. Press the Play/Pause button on the Talkman device to confirm the number.
7. Press the Play/Pause button again to begin working.
Manually Pairing with a Talkman Device
Prerequisites:
• The headset is powered off.
• The Talkman device is not in a charger, and there is no wired headset connected to it.
• The Talkman device is in sleep mode — not in use running a task or voice application. Its green LED
indicator is flashing. If the LED is solid green, press the Play/Pause button.
• The Talkman device is Bluetooth ready with Bluetooth connection features enabled.
1. Turn on the headset.
The LED indicator is solid green. The headset remains in pairing mode for about one minute then
reverts to idle mode.
2. Press and hold the Plus (+) and Minus (-) buttons on the Talkman device for two seconds to manually
initiate a search for wireless headsets.
3. Immediately hold the headset and Talkman device so they are within six inches of each other but not
touching.
The blue LED indicator on the Talkman device turns on, may flash a few times, and then remains
lit. After 20 to 30 seconds, the headset beeps three ascending tones and its LED indicator flashes
blue. These indicators confirm that a pairing has completed.
4. Put on the headset. You will hear the headset repeat the serial number of the Talkman device to
which it is paired.
5. Verify that the number matches the serial number on the Talkman device.
If you need to attempt the pairing again, re-enter pairing mode by press the Plus (+) and Minus (-)
buttons on the Talkman device again.
6. Press the Play/Pause button on the Talkman device to confirm the number.
7. Press the Play/Pause button again to begin working.
Screen-Based Pairing with a Handheld Device
Screen-based pairing is the preferred method for pairing an SRX2 headset with a handheld wireless
device or PC. This method allows the user to pick a specific headset from a list of available headset
Confidential: For informational use by Vocollect Resellers and customers only
136 | Vocollect Hardware Documentation