User's Manual

1.
In VoiceConsole, click Devices and select the device for the pairing.
2.
In Device Actions, select the actions for pairing to a peripheral, and complete the pairing. See
VoiceConsole Online Help for detailed instructions.
The pairing can be performed with the device powered off or while the device is running an application.
When the device powers up or goes into sleep mode, the paging process begins.
3. Place the headset in pairing mode.
• On an SRX headset: press and hold the Plus (+) and Minus (-) buttons for four seconds.
• On an SRX2 headset: press the Power button to turn it on.
4. When the two connect, the headset will play ascending connect tones. The pairing confirmation step
is skipped because the pairing was specified by the user.
5. Press the Play/Pause button to begin working.
More about SRX/SRX2 Pairing Modes
When a headset is in pairing mode it is ready to respond to any inquiries about its Bluetooth services.
The inquiring device uses this response to determine if it wants to pair with the headset. Because the
device is the initiator and the headset is the acceptor, a user facilitates the pairing process by putting
the headset into pairing mode before initiating the connection from the device.
SRX and SRX2 headsets support two pairing modes.
•
Low Power Pairing Mode
Low power pairing mode is the default pairing mode for SRX and SRX2 headsets. In this mode, a
headset will answer a Bluetooth device inquiry with a very low power response that transmits within
a small area (a few feet or so, depending on the receiving capabilities of the inquiring device).
Limiting the wireless transmission helps to avoid an unwanted cross pairing (a pairing with a Bluetooth
address other than the target) by forcing the headset to be in close proximity to the device.
•
High Power Pairing Mode
High power pairing mode allows the headset and device to be separated by more distance because
the headset’s response to inquiries is a wider transmission.
Vocollect recommends using high power pairing only if low power pairing fails. Use this mode with
care: While high power pairing mode makes it more likely that the connection will succeed, it also
increases the likelihood of cross pairing.
If the configuration parameter SrxAutoPairEnable is enabled and the configuration parameter
SrxHighPowerPairingDelaySeconds is set to 0, headsets will skip lower power pairing mode and
enter high power mode.
See
Configuration Parameters for SRX/SRX2 Headsets for more details.
Placing Headsets in Pairing Modes
Pairing Mode ResultSRX2 ControlsSRX ControlsInitial Headset
State
Idle mode
Mode only allows connection
with the last device paired
N/APress and hold Plus (+) and
Minus (-) buttons for 0 to 3
seconds
Off
Confidential: For informational use by Vocollect Resellers and customers only
138 | Vocollect Hardware Documentation