User's Manual

10-Bay Combination Charger Power Supply
UL listed and CSA certified
3 conductor 18 AWG
Cord (U.S., Mexico, Canada):
Terminated with a molded on plug cap rated at
125V 15A
Six feet minimum length
Internationally harmonized and marked <HAR>
3 conductor 0.75mm minimum wire
Cord (other countries):
Rated at 300V with PVC insulated jacket
Mounded on plug cap rated 250V 10A
Six feet minimum length
Single-Bay Combination Charger Power Supply
Input Voltage: 100-240 Vac
Input Current: 0.6 A maximum
Input:
Line Frequency: 50-60 Hz
Connecting the Power Supply to the T1 10-Bay Charger
1. Connect the AC cord to the left end of the power supply that is mounted inside the charger.
2. Route the cable through the plastic clips as shown.
Figure 101: Cable Routed Through Plastic Clips
3. Push the clips to lock the cord in place.
T5/A500 Combination Charger Wall Mount
This unit provides a convenient surface for mounting the T5/A500 10-Bay Combination Charger and its
power supply on a wall.
• Customer assembly required.
• Be aware of potential hazards (electrical wires, waterlines, etc.) when drilling the pilot holes.
Confidential: For informational use by Vocollect Resellers and customers only
150 | Vocollect Hardware Documentation