User's Manual

Figure 106: Screwing the stand into the charger
Charger Wall Mount, Multiple Chargers: T2 Series
This unit provides a convenient surface for mounting five charger units and their associated power
supplies on a wall.
• Customer assembly required.
• Be aware of potential hazards (electrical wires, waterlines, etc.) when drilling the pilot holes.
• Customer assumes all responsibility for the installation of these units.
• A device charger cannot have another charger placed directly above it. A section of dry-erase board
(included) must be placed above each device charger.
• If you drill into a wall stud when drilling a pilot hole for one of the anchors, do not use an anchor with
that hole.
• The lowest anchor for each extrusion must be a minimum of 12 inches from the floor.
• Avoid blocking power outlets and other wall receptacles when installing the extrusions and charger
unit.
Charger Wall Mount, Multiple Chargers: Mounting the Extrusions
Parts List:
DescriptionQuantityItem #
Extrusion21
Self-drilling screw anchor #882
Washer, #8, flat, type B regular83
Screw, #8x1.5 Phillips pan head84
Screw, #10-24x.312 hex, socket head25
Drilling template sheet16
You will need:
• Drill with 1/8” bit
• Screw driver, #2 Phillips
• Allen key, Hex 1/8”
1. Using the drilling template, mark eight holes on the wall for the anchors.
Confidential: For informational use by Vocollect Resellers and customers only
154 | Vocollect Hardware Documentation