User's Manual

The bottom anchor holes must be at least 12 inches from the floor.
2. Drill the pilot holes for the anchors, and screw the anchors into the holes.
3. Align the holes of an extrusions with the installed anchors. The extrusions have a specific inside and
outside edge and must be placed onto the wall correctly. The inside edge of the extrusion has the
T-channel into which the chargers are inserted. See Figure 107: Mounting the Extrusions on page 155
4. Insert a screw through a washer and the hole in the extrusion and into the anchor. Tighten the screw
enough to hold the extrusion in place. Repeat with the other screws and washers.
5. Repeat the previous two steps for the other extrusion.
6. Make sure that the extrusions are vertical and then tighten the screws completely.
7. Locate the small hole in the bottom of the T-channel on the inside edge of each extrusion. Insert one
of the socket head screws (item 5) into both of the bottom holes and tighten them all the way.
Figure 107: Mounting the Extrusions
Charger Wall Mount, Multiple Chargers: Mounting the Power Supply Bracket
Parts List:
DescriptionQuantityItem #
Power supply bracket46
Power supply mounting panel17
Collar with nut28
Washer, #4, flat, type B regular29
Screw #4-40x.625, Phillips pan head210
Washer, #8, flat, type B regular811
Screw #8-32x.5, Phillips pan head812
Nut, #8-32 hex machine screw813
You will need:
• Screw driver, #2 Phillips
• Screw driver, Hex 1/8”
Confidential: For informational use by Vocollect Resellers and customers only
Chargers | 155