User's Manual

• Wrench, 11/32”
1. The two holes at the top of the mounting panel are for the collars that will enable the panel to slide
down into the extrusions. Assemble a collar by placing the small end of the collar against the back of
the mounting panel.
2. Insert the screw through a washer and the hole in the panel, then into the collar. Tighten the screw
all the way. Repeat with the other collar.
3. The eight holes in the middle of the mounting panel are for the power supply brackets. Mount a power
supply bracket to the panel by lining up the holes. Refer to the figure below for the correct positioning
of the bracket.
Figure 108: Mounting the Power Supply Bracket
4. Insert a screw through a washer and a hole in the bracket and the panel. Tighten with a nut.
5. Repeat for the other holes in the bracket.
6. Repeat the last three steps for the remaining brackets
Charger Wall Mount, Multiple Chargers: Fastening the Collars to a Charger
Parts List:
DescriptionQuantityItem #
Collar (611065)1614
Spring, Metric, 6.00x0.60x9.50 long (681006)415
Screw, M3x0.5x16 Phillips pan head (680128)416
Collar placement tool117
You will need:
• Screw driver, #2 Phillips
1. Locate the collar placement tool on the back of the charger so that it is against the charger’s end cap.
2. Position one of the collars against the collar placement tool. Place the collar directly over one of the
charger’s threaded channels.
Confidential: For informational use by Vocollect Resellers and customers only
156 | Vocollect Hardware Documentation