User's Manual

Figure 111: Placing the Bottom Collars into the T-Channels
4. Slide the charger down until it is resting on top of the power supply mounting panel. Make sure that
the two top collars on the back of the charger go into the T-channels as the charger is slid down.
5. Insert a section of dry-erase board into the extrusions and slide it down to the top of the charger. A
section of dry-erase board must be placed above each device charger.
6. Repeat the last three steps for the remaining chargers and dry-erase board sections.
About LED Indicators
Vocollect Talkman devices, SRX and SRX2 headsets, and their chargers have LEDs that indicate the
state of the equipment. These LEDs may be on, off or blink. In some cases an LED will blink, alternating
between two colors.
If the LEDs indicate that there is a problem, refer to information on troubleshooting to solve the problem.
See also
Troubleshooting Problems Indicated by LED.
T2 and T2x Device Charger LED Indicators
Note: The indicators described here only indicate the status of the battery. They do not reflect the
state of the device.
It may take five to 10 seconds for the indicators to accurately report the battery conditions. Allow
some time for the indicators to become stable before making decisions based on the LED indicators.
Note: If there is no device in the charger or if the device in the charger does not have a battery and
one of these conditions occurs, disconnect the charger from its power source for about five seconds,
then reconnect the charger. If the condition persists, return the charger for service.
If a device with a battery is the charger...Right Indicator ColorLeft Indicator Color
Troubleshoot the problemOffOff
The battery is charged and ready to use.GreenOff
The battery is being charged.OffRed
Confidential: For informational use by Vocollect Resellers and customers only
158 | Vocollect Hardware Documentation