User's Manual

3. Drill two pilot holes for wall anchors (not included). The anchors should be spaced 2.75" apart vertically.
4. Install the anchors and screws (not included).
5. Be sure to use both the keyhole slot and screw slot to hang the charger.
SRX Battery Charger Wall Mount: Mounting the SRX 5-Bay Battery Charger
Parts List:
• 4 self-drilling screw anchors #8
• 4 screws, #8 x 1.5 Phillips pan head
You will need:
• Drill with 1/8” bit
• Screw driver, #2 Phillips
1. Mark the location of the anchor holes on the wall, spaced 9" apart horizontally and 2" apart vertically.
Make sure that the bottom anchor holes are at least 12 inches from the floor and level.
2. Drill the pilot holes for the anchors, insert anchors and screws. Leave screw heads sticking out from
the wall.
3. Insert the power supply into the back of the charger as shown. Plug the power supply into the charger
but do not plug it into a power source until after mounting is complete.
Figure 117: Power Supply Plugged into Charger
4. Hang the charger on the screws by lining up the keyhole slots on the back of the charger with the
screw heads on the wall.
Confidential: For informational use by Vocollect Resellers and customers only
166 | Vocollect Hardware Documentation