User's Manual

32° to 104° F (0° to 40° C)Operating Temperature
-40°F to 158°F (-40° to 70°C)Storage Temperature
5% - 95% relative humidity, non-condensingHumidity
SRX2 Battery Charger Wall Mount
The SRX2 battery charger is ready for mounting on a standard DIN rail without any customer
modifications. A DIN rail must be installed on a wall in a suitable location. Vocollect offers a DIN rail
suitable for mounting a single charger, but customers may choose to purchase rails from other suppliers
as long as the rails meet Vocollect specifications. Consider the following before wall mounting your
charger.
Customer assembly required for the rail wall mount.
Customer assumes all responsibility for the installation of charger units.
Installer must verify that the installation meets all local building codes.
Avoid potential hazards (electrical wires, waterlines, and similar building components) when drilling
into the wall.
Avoid blocking power outlets and other wall receptacles when installing the rail and charger.
Anchoring a wall mount rail to a wall stud generally results in a more stable installation. If you drill
into a wall stud, do not use a screw anchor in that hole.
If you are mounting two chargers side by side, you must leave at least 1 in. (2.54 cm.) of space between
the two units to allow clearance for the locking arms.
Rails must be anchored to the wall at least 12 in. (30.5 cm.) from the floor to allow for proper
attachment, seating, and removal of the charger unit.
If you are mounting a charger directly above another charger, Vocollect recommends clearance of at
least 10 in. (25.4 cm.) between DIN rails.
Figure 119: SRX2 charger - back view
DescriptionPart Number in Diagram
power supply
1
rubber stop for leveling charger against wall
2
locking arm for securing charger to DIN rail
3
mounting hook for hanging charger on DIN rail
4
USB port for charger software upgrades
5
Mounting the SRX2 20-Bay Battery Charger
You will need:
Confidential: For informational use by Vocollect Resellers and customers only
168 | Vocollect Hardware Documentation