User's Manual

• DIN rail, slotted steel 35 mm X 15 mm, Vocollect Part #CM-1000-20-1 or customer-supplied DIN rail
meeting the following specifications
Standard DIN railDIN rail specsMinimum cut
lengths for
rail
Number of
chargers on
rail
Single unit length 550 mm; weight
331.5 g (11.6933 oz)
550 mm1
1101 mm2
1652 mm3
• Drill
• Fasteners
• Screw driver
1. Install the DIN rail on the wall in the desired location. Ensure that the secure installation, supporting
surface, and mounting hardware will safely support the weight of a fully loaded charger, at 25 lbs.
per linear foot (37.2 kg/m) of DIN rail. Ensure that the anchor holes are at least 12 inches (30.5 cm.)
from the floor. Verify that the installation meets all local building codes.
2.
Important: The power supply for the charger should already be zip-tied in the back of the charger
chassis. If it is not, plug the power supply into the charger and secure it. Do not plug it into a
power source until after mounting is complete.
Before attaching the charger to the rail, open the locking arms on the back of the unit by rotating the
two levers out on each side of the charger. The arms are parallel to the floor in the unlocked position.
3. Attach the charger to the DIN rail by hanging the two hooks on the back of the unit on the top lip of
the rail.
Attaching the SRX2 Charger to a DIN Rail
4. Slide the charger horizontally to the desired position on the rail, and rotate the locking arms into the
locked position - flush with both sides of the unit.
Confidential: For informational use by Vocollect Resellers and customers only
Chargers | 169