User's Manual

Figure 130: Set Up Scanner as Slave
3. Using VoiceConsole, locate the specific Talkman T5 device to be paired with the scanner.
4.
View the properties of the device, and ensure that Bluetooth is enabled. If it is not enabled, click Edit
this device and set Bluetooth Enabled to "enabled."
5.
Select the Pair this device with a peripheral option.
6.
For Pairing Type select "Bluetooth Scanner."
7.
For Connection Mode select "Device initaties connection with peripheral."
8.
In the Bluetooth Adress enter the Bluetooth MAC address of the scanner. This 12-character ID is
labeled "MAC ID" and is found on the side of the battery unit of the scanner.
9.
Click Pair with peripheral to initiate pairing.
Pairing the Honeywell LXE 8652 Scanner: Scanner Is the Initiator
During use, it is possible for the scanner to disconnect from the device if the communication link is
disrupted. When the scanner is setup so that the device initiates the connection, the device typically
recovers the connection automatically. When the scanner initiates the connection, it typically requires
the press of a button to activate and recover the connection..
This method of pairing is useful if a scanner will be used with more than one Talkman T5 Series device.
You must have access to VoiceConsole to set up the pairing. For production use, Vocollect recommends
that you create a specific device profile in VoiceConsole to store many of the following settings.
1. Ensure that the Talkman is labeled with a code 128 barcode. This code contains the FNC3 code
followed by the capital letter "B" and the unique Bluetooth MAC address of the Talkman.
a) If the Talkman does not have a barcode label, generate the FNC3 on a PC with a full keyboard
and number pad. Hold the ALT key down and press the four-number sequence "1 0 7 9" on the
number pad. A small number 3 will appear to indicate the presence of the code. Some barcode
software packages have special insertion keystrokes for FNC3.
b) Find the Bluetooth MAC address of the Talkman on the rear of the device near the belt clip. The
address begins with "BT."
2. Print this page.
3. Using VoiceConsole, locate the specific Talkman T5 device to be paired with the scanner.
4.
View the properties of the device, and ensure that Bluetooth is enabled. If it is not enabled, click Edit
this device and set Bluetooth Enabled to "enabled."
5.
Select the Pair this device with a peripheral option.
6.
For Pairing Type select "Bluetooth Scanner."
7.
For Connection Mode select "Device listens for peripheral connection."
8.
Click Pair with peripheral to initiate pairing.
9. To complete the pairing, scan the barcode created for the Talkman device in first step.
10. When finished using the Talkman and scanner, unpair the Talkman by scanning the following barcode
to set the scanner to slave mode.
Confidential: For informational use by Vocollect Resellers and customers only
Bar Code Readers and Printers | 181