User's Manual

Note: Performing this step ensures that the scanner does not generate spurious Bluetooth RF
that could interfere with other transmissions.
Figure 131: Reset Scanner as Slave
Note: To pair the scanner again, rescan the Talkman code 128 barcode.
Honeywell IS4225 Bar Code Reader
Figure 132: Honeywell (Metrologic) IS4225 Bar Code Reader replaces the IS4220
• The small hole at the rear of the bar code reader near the cable is the speaker that the reader uses
to provide a confirming "beep" when a code has been successfully read. It is not a reset button. Objects
should not be pushed through this opening because they will damage the speaker and possibly cause
the reader to malfunction. This type of damage is not considered a warranty/repair item.
• For detailed specifications for this product, visit the Honeywell website.
Honeywell IS4220 Bar Code Reader Specifications
Bar Code Reader Firmware Defaults
• The reader transmits at 9600 baud, 8 bits, no parity, 1 stop bit.
• The default suffix values of Carriage Return (hex 0D) and Line Feed (hex 0A) are sent after each
scan.
• A confirming ‘beep’ tone is heard after each scan.
• Code scanned must be a minimum of 3 characters.
• Codes UPC, EAN, Code 39, Codabar, Code 128, Code 93, Interleaved 2 of 5 are enabled.
Vocollect RJ11 Connection Cable
• The Vocollect RJ11 connection cable (Symbol part # 735058) is used to connect a to a device.
• This connection cable has a Vocollect connector on one end (which connects to the device) and an RJ11
connector on the other end. Additional Symbol parts that are needed are as follows:
Confidential: For informational use by Vocollect Resellers and customers only
182 | Vocollect Hardware Documentation