User's Manual

Figure 155: Connecting the Cable to the Talkman Device
2. Make sure the peripheral is off.
3. Connect the cable to the peripheral.
4. Turn the peripheral on.
• To connect the SL-4 light duty behind-the-head headset to a Talkman T1 device, insert the IOC
connector on the end of the headset cable into the connection port on the T1 device.
• To connect the SR-21 Universal Lightweight Headset to a handheld device, insert the 2.5mm
universal connector on the end of the headset wire into the connection port on the handheld device.
Disconnecting Peripherals from a Talkman Device
Caution: Never pull on the cable or twist the connector to disconnect it from the device. Doing so
will damage the cable and connector, and invalidate the headset's warranty.
1. Grasp the connector.
2. Press the connector's release lever.
3. Tilt the bottom of the connector off the device.
4. Lift the connector up and off the device.
• To disconnect the SL-4 light industrial behind-the-head headset from a Talkman T1 device, grasp
the IOC connector on the end of the headset cable and pull it out of the connection port on the T1
device. Do not pull the headset wire.
• To disconnect the SR-21 Universal Lightweight Headset from a handheld device, grasp the 2.5mm
universal connector on the end of the headset wire and pull it out of the connection port. Do not
pull the headset wire.
About Pairing Peripheral Devices
• Pairing recommendations may differ from peripheral to peripheral and configuration. Please see your
device and peripheral documentation.
• If you are using Bluetooth, ensure that the Bluetooth radio has been turned on through the device's
operating system. Most devices have the ability to turn the Bluetooth radio on or off. For power
consumption reasons, when Bluetooth is not in use, the Bluetooth radio should be turned off. This
process differs per device. Please see your device and peripheral documentation.
Confidential: For informational use by Vocollect Resellers and customers only
Bar Code Readers and Printers | 197