User's Manual

• If you are using a handheld device, make sure to use the correct audio adapter training cable for
your device.
3. Insert the 3.5mm male jack into the INPUT connector on the Samson transmitter.
4. Power on the transmitting radio.
5. Assure that output is enabled with the Mute/Audio switch set to the connect position.
• For TR-605-x units, slide the Audio switch to ON.
Setting up the Receiving Radio
The receiving radio is set up as a dedicated receiver for use by a trainer.
Figure 168: Receiving Radio TR-605-x
1. Insert a battery into the grey receiving radio.
2. Connect a headset or powered speaker to the receiver's headphone jack.
3. Power on the receiving radio.
4. If needed adjust output level (indicated by #1 in yellow above).
Adjusting the Listening System for Optimum Performance
1. Press the Plus button on your Talkman device or handheld device until the volume reaches its
maximum setting.
You will hear “This is loudest”.
2. On the transmitting radio, locate the adjustment indicated as #1 on the transmitting unit. Align a
small screwdriver tip with the slot in the control screw and use gentle pressure to fully rotate the
control screw counterclockwise to set the gain to its minimum setting. Use extra care if you use a
metal screwdriver as metal may damage the gain controls.
3. On the receiving radio, locate the control marked #1. Gently rotate the control screw counterclockwise
to set the headphone volume to its minimum setting.
4. On the gray receiving radio, turn the Phones Level setting back clockwise approximately 20 degrees.
5. Power on both listening system radios.
6. Put on the gray receiving radio's headphones or powered speaker.
7. Press the Plus or Minus buttons on the Talkman device or handheld device as you adjust the receiving
radio's headset volume to the maximum desired level.
8. Make additional adjustments:
Confidential: For informational use by Vocollect Resellers and customers only
224 | Vocollect Hardware Documentation