User's Manual

When the battery is placed into the charger properly, the left LED indicator for the slot into which
the battery was placed turns red.
Note: The upper set of LED indicators apply to the charger's battery slots and the lower indicators
apply to the devices' slots.
Removing an A500, T2-Series or T5-Series Device From a Charger
Note: The device is ready to use when the LED indicator on the device is blinking green. If the LED
is blinking red, the device is not ready to be used.
Important: If a device continuously displays a solid red light, contact your system administrator.
1. Make sure that the device is ready to use.
2. Pull up on the device to remove it from the device charger.
Figure 4: Removing a Device from a Charger
Inserting a Battery into a Talkman A500, T5-Series or T2-Series Device
Make sure the battery to be inserted is fully charged.
1. Hold the Talkman so that the red and yellow ports are facing away from you.
2. Hold the battery with the pins facing away from you and so that the Vocollect logo is on top.
3. Place the battery in at an angle, pins end first.
Figure 5: Properly Inserting a Battery
Confidential: For informational use by Vocollect Resellers and customers only
38 | Vocollect Hardware Documentation