User's Manual

Pairing with the Honeywell MS9535: Talkman Device Is the Acceptor
The Talkman A500 and T5 devices must be configured in VoiceConsole to listen for incoming connections
before proceeding with these instructions. See the VoiceConsole online help for details.
For a T5 device, you must set the parameter Bluetooth_IsDiscoverable=true in the device properties in
VoiceConsole so that the device will broadcast its address.
Important: Only one scanner should be configured to communicate with a Talkman device's
Bluetooth address at any one time. If you change the bar code reader to which the device has been
paired, you must clear the Bluetooth service in the old bar code reader. Scan the Provide Bluetooth
Service bar code (3000CA7000000). See the documentation that came with the Honeywell scanner
for details.
1. With the Honeywell scanner, scan the Provide Bluetooth Service bar code (3000CA7000000). See the
documentation that came with the Honeywell scanner for details.
2. Power off the Talkman device completely and then power it back on.
3. Place the Talkman device into sleep mode or wait for it to enter sleep mode.
The green LED on the device blinks green.
4. Wait for 30 seconds.
5. Scan the Get Bluetooth Address bar code (3000CA7FFFFFF) from the Honeywell user's guide.
6. Scan the bar code on the Talkman device. This bar code contains the Talkman device's Bluetooth
address.
You will hear a quick, three-beep confirmation from the bar code reader, followed by a
low-tone/high-tone beep indicating success.
Pairing with Zebra QL Series Printers
For Bluetooth pairing:
• In VoiceConsole, find the device and use the appropriate action link to pair it to a peripheral.
• See VoiceConsole Help for detailed instructions on pairing devices.
• Create the pairing with the Zebra
®
QL
™
Series printer.
Pairing with Intermec PB50 Printers
Please refer to Intermec documentation on configuring the PB50 for Vocollect applications.
For Bluetooth pairing:
• In VoiceConsole, find the device and use the appropriate action link to pair it to a peripheral.
• See VoiceConsole Help for detailed instructions on pairing devices.
• Create the pairing with the Intermec
®
PB50 mobile printer.
For Wireless Network (WiFi) pairing:
• In VoiceConsole, find the device and use the appropriate action link to pair it to a peripheral.
• Enter the printer's Pairing Name, Host, and Port.
The default TCP/IP port for the PB50 printer is 9100.
• See VoiceConsole Help for detailed instructions on pairing devices.
Pairing the Honeywell LXE 8652 Scanner: Talkman Device Is the Initiator
During use, it is possible for the scanner to disconnect from the device if the communication link is
disrupted. When the scanner is setup so that the device initiates the connection, the device typically
Confidential: For informational use by Vocollect Resellers and customers only
66 | Vocollect Hardware Documentation