User's Manual

• Cables should be kept clear of surfaces that may become hot.
• Cables should not be run such that they can get caught on moving parts.
• Cables should not be run on the outside of a vehicle.
• Cables should not have 90 degree turns, the minimum bend radius should not be less than one
inch
• To remove slack on a cable it should be coiled up and secured inside the vehicle with a cable tie.
• For maximum safety fuses should be located as close as possible to the power source.
• To protect the A500/T5 VMT from power surges and to perform voltage conversion a converter
module is fitted between the A500/T5 VMT and the forklift battery.
1. Disconnect the vehicle battery.
2. Remove the four screws from the top of the power supply to expose the screw terminals.
3. On the cable from power supply to the vehicle’s power source, strip the three cables to expose
approximately 5mm of copper. Ensure the cable is long enough to reach from the power supply to the
vehicle’s power source.
4. On the yellow cable from the battery adapter to the power supply, strip the black and brown cable to
expose approximately 5mm of copper. The Blue cable is not required; it can be trimmed where it exits
the yellow cable. Ensure the cable is long enough to reach from the power supply to the vehicle’s
power source.
5. Connect the cables from the battery adapter to the power supply by performing the steps below.
• Loosen the screws to where the connection will be made on the power supply.
• Match the cables to the correct locations as indicated in the chart below:
•
Output ConnectorCable
+Brown – Battery Adapter Positive
-Black – Battery Adapter Negative
GNDNo connection needed
Not applicableBlue (cut back)
• Tighten the screws.
• Ensure the cables are secure
6. Connect the cables from the vehicle’s power source to the power supply by performing the steps below:
• Loosen the screws to where the connection will be made on the power supply.
• Match the cables to the correct locations as indicated in the chart below:
•
Input ConnectorCable
+White (may differ depending on the cable) – Vehicle Positive
-Black (may differ depending on the cable) – Vehicle Negative
GNDGreen - Vehicle Ground
• Tighten the screws.
• Ensure the cables are secure
7. Once all of the cables have been successfully installed, attach cable ties to secure the cables.
Confidential: For informational use by Vocollect Resellers and customers only
Talkman T5 Series | 73