User's Manual

4. Expose approximately 10mm of copper on the positive and negative wires.
5. Insert the exposed copper into the fuseholders and crimp into the positive and negative wires using
an approved tool.
6. Connect the green wire to the vehicle's ground.
7. Connect the fused white wire to the vehicle’s positive power source using an appropriate connector.
This may need to be crimped onto the wire.
8. Connect the fused black wire to the vehicle’s negative power source using an appropriate connector.
This may need to be crimped onto the wire.
9. Attach the power supply as shown in the following diagram.
Figure 50: Attach the Power Supply
10. Secure the wires with cable ties.
Removal of Talkman A500/T5 VMT Mobile Computer from Vehicle
Talkman A500/T5 VMT mobile computer components are designed for easy removal for occasional vehicle
service, maintenance or flexible operational needs.
Caution: Vocollect does not recommend removing the cables (CM-710-101, CM-710-102) from the
battery adapter except when required for occasional service (i.e. once per month at maximum)
Excessive removal of these cables may damage the adapter and cable. This type of use is not covered
under warranty or service plans as it is unintended product use that is specifically not recommended.
1. Release the battery adapter from the device.
2. Dock the battery adapter in the side of the VMT holder.
This leaves the device free to be removed and the battery adapter and cable docked and protected.
Confidential: For informational use by Vocollect Resellers and customers only
Talkman T5 Series | 75