User's Manual

Caution: Do not attempt to place the device into the charger unless you have first disconnected
the headset and any other peripheral devices. Do not remove the battery from the device when
placing the device into a charger.
7. After the device has been placed into the charger, make sure that the LED indicator on the device
turns on and begins to blink green.
a) If the LED does not turn on after 30 seconds, remove the device from the charger slot and then
place it into the slot again.
b) If the LED indicator still does not turn on, try another charger slot.
Caution: If the LED indicator on a device is blinking red, do not remove the device from the charger.
Removing an A500, T2-Series or T5-Series Device From a Charger
Note: The device is ready to use when the LED indicator on the device is blinking green. If the LED
is blinking red, the device is not ready to be used.
Important: If a device continuously displays a solid red light, contact your system administrator.
1. Make sure that the device is ready to use.
2. Pull up on the device to remove it from the device charger.
Figure 60: Removing a Device from a Charger
Inserting a Battery into a Talkman A500, T5-Series or T2-Series Device
Make sure the battery to be inserted is fully charged.
1. Hold the Talkman so that the red and yellow ports are facing away from you.
2. Hold the battery with the pins facing away from you and so that the Vocollect logo is on top.
3. Place the battery in at an angle, pins end first.
Confidential: For informational use by Vocollect Resellers and customers only
84 | Vocollect Hardware Documentation