User's Manual

a) If the LED does not turn on after 30 seconds, remove the wearable computer from the charger slot and
then place it into the slot again.
b) If the LED indicator still does not turn on, try another charger slot.
Caution: Do not attempt to place the device into the charger unless you have first disconnected the
headset and any other peripheral devices. Do not remove the battery from the device when placing a
device into a charger.
Charging a T2 Series Device
1. Make sure the charger is powered. The charger's orange power light (LED indicator) is lit when the charger
is powered.
2. Sign off of the device if necessary.
3. Press and hold the yellow play/pause button until the LED indicator turns solid red and then turns off.
4. Remove the device from the belt clip.
5. Disconnect any other peripherals. If the device is in a cover, remove the cover.
6. Insert the device into one of the device charger slots with the button controls of the device to the top and
facing toward the left.
Figure 6: Inserting a T2 Series Device Into a Charger
7. After the wearable computer has been placed into the charger, make sure that the LED indicator on the
wearable computer turns on and begins to blink green.
a) If the LED does not turn on after 30 seconds, remove the wearable computer from the charger slot and
then place it into the slot again.
b) If the LED indicator still does not turn on, try another charger slot.
OpenTopic | Talkman
®
Devices | 23