User's Manual

Note:
• If you say "Talkman back up" more than once, the wearable computer continues to back up to
previous prompts until it reaches a point where it cannot back up anymore (such as a point where
data has already been transmitted to the host computer).
• If you say "Say again" more than once, the device continues to repeat the last thing it said (that
is, the current prompt) again and again. It will not back up any further than the previous prompt.
Pairing an A500 or T5 Wearable Computer and a Bluetooth
®
Device
Note: Currently, you can associate one printer and/or one bar code reader to the same A500 or T5-series
device. You cannot associate multiple printers or bar code readers to a single wearable computer.
Note: You can also associate a Pidion 170 display with an A500 device.
Pairing an A500 or T5-Series With the Metrologic MS9535: Talkman Device Is the Initiator
1. In VoiceConsole, follow the instructions for creating a pairing and setting the bar code reader as the
acceptor. See VoiceConsole's Help for details.
2. Scan the Code 128 bar code (3000CA7000000). See the documentation that came with the Metrologic
9535 for details.
3. Place the Talkman device and bar code reader close together. The Talkman device associates with the
bar code reader. A low-tone/high-tone beep from the bar code reader indicates a successful association.
Note: If a bar code reader goes out of communication range with the Talkman device, it may un-pair
from the Talkman device. You will hear a high-tone/low-tone beep. Move the bar code reader closer to
the Talkman to reassociate the bar code reader with the Talkman device. You will hear a low-tone/high-tone
beep when they pair.
Pairing an A500 or T5-Series With the Metrologic MS9535: Talkman Device Is the Acceptor
The Talkman A500 and T5 devices must be configured in VoiceConsole to listen for incoming connections
before proceeding with these instructions. See the VoiceConsole online help for details.
Note: Do not attempt to pair the Metrologic scanner until the Talkman device is powered off.
Important: Only one scanner should be configured to communicate with a Talkman device's Bluetooth
address at any one time. If you change the bar code reader to which the wearable computer has been
paired, you must clear the Bluetooth service in the old bar code reader. Scan the Provide Bluetooth
Service bar code (3000CA7000000). See the documentation that came with the Metrologic scanner for
details.
1. With the Metrologic scanner, scan the Provide Bluetooth Service bar code (3000CA7000000). See the
documentation that came with the Metrologic scanner for details.
2. Power off the Talkman device completely and then power it back on.
3. Place the Talman device into sleep mode or wait for it to enter sleep mode.
The green LED on the wearable computer blinks green.
4. Wait for 30 seconds.
5. Scan the Get Bluetooth Address bar code (3000CA7FFFFFF) from the Metrologic user's guide.
28 | OpenTopic | Talkman
®
Devices