User Manual

113
follows the terminal, the
battery, or the charger module;
return the faulty equipment for
service.
Solid
Orange
Solid Green Charger
module is
malfunctionin
g; return for
service.
Charger module
is
malfunctioning;
return for
service.
Normal state; this state only
occurs for about a second
when a terminal is removed
from the charger; if this state
occurs for an extended period
of time, it is an abnormal
condition and should treated
the same as the abnormal
conditions listed above.
The length of time that it takes to completely charge a fully depleted battery is approximately
3 hours for the standard battery and 5 hours and 30 minutes for the high capacity battery. This
does not include any time that may be necessary to bring a battery that is too cold, too warm,
or completely dead into a charging state (a battery that is too cold, too warm, or completely
dead needs to warm up, cool down, or partially charge before it actually enters a fast charging
state).
Note: It is recommended that a brush similar to the one found at the following link be used
to clean the contacts on the terminal, battery, and charger. Gently brush the contacts to
clean away dirt and other obstructions that might prohibit them from making a solid
connection.
http://web-tronics/852.html
The brush found at this link is a small, inexpensive, three-row toothbrush style, general
cleaning brush. It is made of natural, stiff hog hair bristles and has a 7 3/4" plywood handle.
This brush is excellent for general circuit board cleanup.
Procedure
To place a Talkman terminal into a terminal charger, perform the following steps:
1. Make sure the charger is powered. The charger's orange power light (i.e. LED indicator)
is lit when the charger is powered.
2. If you sign on and sign off terminals at your site, sign off the terminal.
3. Press and hold the yellow play/pause button until the LED indicator turns solid red and
then turns off. If you have any question about properly turning off a terminal, see
Turning Off a Talkman Terminal.
Note: It is not absolutely necessary to turn the terminal off before placing it into the
charger.
4. Remove the Talkman terminal from the belt clip.
5. Disconnect the headset.
6. Disconnect any other peripherals that are connected to the terminal.
7. If you are using a terminal cover with the terminal, remove the cover from the
terminal. See Using a Terminal Cover.
8. Insert the Talkman terminal into one of the terminal charger slots with the button
controls of the terminal to the top and facing toward the left.
Warning: Do not attempt to place the Talkman terminal into a terminal charger
unless you have first disconnected the headset and any other peripheral devices.
Also, do not remove the battery from the terminal when placing a terminal into a
charger.
9. After the terminal has been placed into the charger, make sure that the LED indicator
on the terminal turns on and that it eventually begins to blink green. When the