User Manual

34
Humidity: 95% non-condensing
Rain/dust: IP67
• The pin out from left to right (when looking at the contacts with the battery's label
facing down) is as follows:
Battery +
Thermistor
ID Data
Battery -
Cleaning Battery Contacts
It is recommended that a brush similar to the one found at the following link be used to clean
the contacts on the battery. Gently brush the contacts to clean away dirt and other
obstructions that might prohibit them from making a solid connection.
http://web-tronics/852.html
The brush found at this link is a small, inexpensive, three-row toothbrush style, general
cleaning brush. It is made of natural, stiff hog hair bristles and has a 7 3/4" plywood handle.
This brush is excellent for general circuit board cleanup.
Talkman® T2 Battery Chargers
Note: The information in this topic applies specifically to the Talkman® T2
system. To view this information for the Talkman® OPEN system, click on
the image of the terminal.
• Overview
• Procedures
• Specifications
Overview
Talkman® T2 terminal batteries can be charged in the terminal charger, however, a
separate battery charger is also available. The battery charger is only available in one
model that includes five battery slots. The charger can be used to store and charge up to
and including five batteries at a time.
The battery charger comes with either a desk mount or a wall mount. The desk mount is
used to set the charger upright on a desk or table and the wall mount is used to mount the
entire unit to a wall.
Procedures
• Changing a Battery
• Charging a Battery in a Battery Charger
Specifications
Length
Approximately 24" (61
cm)
Length (with desk Approximately 24" (61