User Manual

88
speech input. If set to 1,
SpeechOutSpeechIn Delay
determines how much of the
priority prompt can be talked
over.
ODRConfirmationByte
It is possible to guarantee that
an output data record (ODR)
was acted upon by the host
application by forcing the
terminal to wait for the host
application to confirm the
receipt of the ODR. This
parameter is used to enable
the receipt confirmation.
Setting this parameter to any
value of between 0x00 to 0xFF
forces the terminal to wait for
the host application to respond
with the appropriate
confirmation byte (i.e. the
value of the parameter) when
an ODR is sent from the
terminal.
For example, if this parameter
is set to 0x50, then the
terminal software does not
consider the transmission of an
ODR to be a success until the
host application sends the byte
0x50 back to the terminal. If
any other character is sent to
the terminal (or no character is
sent), the transmission of the
ODR is considered to have
failed.
Minimum value = 0x00
Maximum value = 0xFF
This value can be input in the
format 0x00 or as a single
alphanumeric character (such
as A-Z, a-z, or 1-9).
The value 0x100 is also valid
for this parameter. When the
parameter is set to this value,
the terminal will wait for a
confirmation byte from the
host application. However, the
byte will not be compared to
tany expected value (i.e. any
byte sent back to the terminal
will be accepted as
confirmation that the ODR was
received by the host
application).
OutputVolume Determines the initial setting
of the terminal speech output
volume
1 - 10
6
PrinterBaud Sets the baud rate for the
printer port.
50, 75, 100, 150, 300, 600,
1200, 1800, 2000, 2400, 3600,
4800, 7200, 9600, 19200,
31250, 38400
PrinterFlowControl Controls whether hardware
flow control is enabled or
disabled on the printer port.
0 = disable
1 = enable
PrinterParity Parity for the printer port. 1 = no parity
2 = odd parity
3 = even parity
4 = mark parity
5 = space parity
PrinterPort The port on the terminal
where the printer message is
sent.
Red or Blue
PrintStopBits The number of stop bits for the 1