User's Manual

9
Rear Panel Descriptions
SONIC
ENHANCER
REAR MIC INPUT
VIDEO IN VIDEO OUT
BGV DVD AUX
L
R R
L L
R R
L
1 2 3
MIC-OUT
MONO
INTERNAL
EXIT
GND
REMOTE IN
(MONO) L
MONO
SPEAKER IMPEDANCE
SPEAKER SYSTEM
CAUTION:FOR CONTINUED PROTECTION AGAINST
FIRE HAZARD, REPLACE ONLY WITH SAME TYPE FUSE.
110-220V~18.A 250V.
220-240V~T4A 250V.
KARAOKE AMPLIFIER
11-220V/220-240V~50/60HZ
POWER CONSUMPTION:175W
MAX POWER CONSUMPTION: 690W
LA VERNE CALIFORNIA
U.S.A
CAUTION:SHOCK HAZARD, DO NOT REMOVE SCREWS.
ATTENTION: RISQUE DE CHOC ELECTRIQUE.
NE PAS ENLEVER LES VIS.
VOLTAGE SELECTOR
220-240V ~110-120V~
AC OUTLETS
SAME AS LINE VOLTAGE
UNSWITCHED 300W
MAX TOTAL
MADE IN TAIWAN
www.vocopro.com
R
+ -
L
R R
L
R L
MIC-RETURN-IN
INPUT
LEVEL-ADJ
ON
MIC B IN
L M H
AUTO F LEVEL
DVD IN AUX IN
AUDIO
SERIAL NO.
L M H
AUTO F LEVEL
TAPE IN TAPE
(MUSIC BYPASS)
STEREO
MONO
MIN MAX
INPUT
LEVEL
BGM IN PRE-OUT
SYSTEM
1
1
2
2
SYSTEM
SYSTEM
AND
:MINIMUM 4 HOMS
:MINIMUM 4 HOMS
:MINIMUM 8 HOMS
L M H
AUTO F LEVEL
(LINE LEVEL)
MIN MAX
1
2
- +
1
2
3
4
5
6
7
8
9 10
11 12
13
14
15
16
1. VOLTAGE Selector – Before you amplifier is shipped from the factory, the switch is set to 110-120V. If you move 
to an area where the voltage requirements differ, set under the responsibility of the user according to the local 
power voltage. Be sure to replace the fuse with the specified after changing the voltage setting.
(110-120V~7A 220-240~3.5A)
2. SPEAKER SYSTEMS Terminals – Connect with the speaker OUTPUT jacks.
SPEAKER IMPEDANCE SYSTEM 1: 4-ohm
SYSTEM 2: 4-ohm
SYSTEM 1 AND 2: 8-ohm
3. Monaural Pre-Out Jacks – Connect with the INPUT jacks of a powered monitor speaker etc.
4. VIDEO Output Jacks – Connect with the video INPUT of the monitor TV.
5. AUX Video Input Jack – Connect the video OUTPUT jack of an external video player to this jack.
6. DVD Video Input Jack – Connect the video OUTPUT jack of the player to this jack.
7. BGV Input Jack – Connect the video OUTPUT jack of the background video player, video camera, etc., to
this jack.
8. Microphone B Input Jacks – Connect the OUTPUT jack of the wireless microphone receiver.
9. DVD Input Jacks – Connect the OUTPUT jacks of the player to these jacks.
10. AUX Input Jacks – Connect the OUTPUT jacks of the Source to these jacks.
11. TAPE Input jacks – Connect the OUTPUT jacks of the TAPE deck to these jacks.
12. TAPE Output Jacks – Connect the INPUT jacks of the TAPE deck to these jacks.
13. BGM Input Jacks – Connect the OUTPUT jacks of the BGM device (cable broadcasting) to these jacks.
14. PRE-OUT Output Jacks – Connect the INPUT jacks of the extension Power amplifier or the Mixer
to these jacks.
15. BGM (Background Music) Input Level Control-Adjust this control to optimize the BGM input level.
Note that the BGM level cannot be varied by the MUSIC VOL. control on the front panel.
16. GROUND Terminal – The grounding wire to be connected to a grounding line is connected here.