Owner`s manual

REAR PANEL

8. VIDEO OUT (3) –

The DTX-5000G has 3 RCA style VIDEO OUT jacks. These VIDEO OUT jacks supply video to

monitors, TFT displays and compatible TV’s. Connect RCA style video cables from these VIDEO OUT jacks to the

VIDEO IN jacks on your display devices.

NOTE:

You will not be able to use the OSD (On-Screen Display) with VIDEO OUT jack 1, as that jack is

designed to be connected to a karaoke singer’s monitor, and OSD display text would distract the singer.

9. AUDIO IN (3) –

These AUDIO IN jacks are for connecting the audio portion of input devices to the DTX-5000G.

Connect RCA style cables from these AUDIO IN jacks to the AUDIO OUT jacks on your input devices.

NOTE:

These AUDIO IN jacks are designed for devices without digital outputs. If you have connected a device

via a digital jack (OPT/COAX), you do not need to also connect audio cables to these AUDIO IN jacks, as audio

signals are passed through the digital cables.

10. AUDIO OUT (2) –

These AUDIO OUT jacks are for connecting the DTX-5000G to power amplifiers, pre-amps,

receivers or recording devices. It is important to note a difference between the two AUDIO OUT jacks:

•

AUDIO OUT 1

is designed for connection directly to a power amplifier. Output signals from AUDIO OUT 1 are

“hotter” than signals from AUDIO OUT 2. This is so since power amplifiers require more signal input.

NOTE:

Connecting the DTX-5000G to a pre-amp or receiver from this AUDIO OUT

jack may overdrive the pre-amp/receiver.

•

AUDIO OUT 2

is designed for connection to pre-amps, receivers or recording devices. Output signals from

AUDIO OUT 2 are “less hot” than signals from AUDIO OUT 1. This is so since pre-amps/receivers require less

signal input.

NOTE:

Connecting the DTX-5000G to a power amplifier from this AUDIO OUT jack will not utilize the power

amplifiers total output.