Operating instructions

House of Worship/Full Band

For this example, there are four microphones connected to

channels 1-4. These microphones can either be the optional

UHF wireless channels, low-impedance corded microphones,

or high-impedance corded microphones. Musical

instruments are connected to channels 5-8. Note that when

connecting instruments to channels 5-8, the LEVEL control

will need to be set rather high due to the lower signal level

from instrument output. It is preferable to use channels 1-4

for instruments if you are using less than four microphones.

If there is a need to connect a laptop or other stereo music

source, you can connect to the designated stereo inputs on

channels 5/6-7/8.

For power output in this example, the PA-PRO 900 is

conﬁ gured for MAIN L/R+MONITOR output. A pair of

passive speakers is powered via the MAIN L./R speaker

connector. A passive monitor speaker is powered via the

MONITOR speaker connector. An additional set of powered

speakers can be connected to the MAIN OUT jacks on the

front panel.

Recording can be done either with an optional SDR-3 SD

recorder (optional accessory), or to an external recording

device connected to the RCA record out jacks on the front

panel.

NOTES:

UHF wireless mic channels require the SOURCE SELECT

switch to be set to UHF.

POWER AMP ASSIGN switch must be best to MAIN L/

R+MONITOR

Hookup Diagrams