User's Manual

10
Getting Started
Installing the TWIN-BANK
The TWIN-BANK can be installed to standard 19” equipment rack or case. The TWIN-BANK requires a total
of six units of rack space. Follow the steps below for installation.
The main unit requires three rack units.* Place the main unit into the rack or case so that the holes are
aligned evenly. Using four rack case screws (not included) fasten the main unit to the rack case using an
alternating “X” rotation to ensure even tension and alignment.
*You will need to remove the four rubber feet on the bottom of the main unit for an exact three rack unit fit.
Using the same “X” rotation, fasten the remote unit to the rack case using an alternating “X” rotation to
ensure even tension and alignment.
Removing the Rubber Feet from the
Main Unit
On the bottom of the main unit, using a
Phillips-head screwdriver, unscrew each
rubber foot and store in a safe place.