User's Manual

13
Getting Connected
Connecting Component Video Output
Use the component video jacks for Y/Pb/Pr and Y/Cb/Cr video output. Both video modes use the same
connection. Use Y/Pb/Pr for progressive scan mode and Y/Cb/Cr for analog mode. (See the Setup Menu
for setting video output).
Cable required
Component video cable*
Connect one end of the component video cable to the Y/Pb/Pr jacks on the TWIN-BANK, and connect the
other end to a Y/Pb/Pr or Y/Cb/Cr input on your TV or display device.
* Component video cables are labeled making them easier to connect. If you do not have component video
cables, you can use RCA-type cables as well. You just need to keep track of which cable is which.
Connecting S-video Output
S-VIDEO provides better color separation and better resolution by separating the color and picture signals of
a composite video signal. (See Setup Menu section for setting video output.)
Cable required
S-video cable
Connect one end of the S-video cable to the S-video jack on Drive A/B of the TWIN-BANK, and connect the
other end to an S-video input on your TV or display device.
TWIN-BANK
controller boxA
CENTER
FRONT R STEREO R
STEREO L
VIDEO
Y
Cb/Pb
Cr/Pr
COAXIAL
S-VIDEO OPTICAL
SURROUND R
SUBWOOFER
MIXED
AUDIO OUT
DIGITAL
AUDIO OUT
5.1 CH SURROUND AUDIO OUT
VIDEO OUT
FRONT LSURROUND L
MR SW SR
FR COAXIAL V/Pb S-VIDEO OPTICAL
SL
FL Y U/Pb VIDEO
CENML
RCA Component
Video Cable
DISPLAY DEVICE
controller boxA
FRONT R
STEREO R
STEREO L
VIDEO
Y
Cb/Pb
Cr/Pr
COAXIAL
S-VIDEO OPTICAL
MIXED
AUDIO OUT
DIGITAL
AUDIO OUT
5.1 CH SURROUND AUDIO OUT
VIDEO OUT
FRONT L
MR SW SR
FR COAXIAL V/Pb S-VIDEO OPTICAL
SL
FL Y U/Pb VIDEO
CENML
DISPLAY DEVICE
S-VIDEO Cable