User's Manual

Getting Connected

Installing the UHF-18 DIAMOND in a compatible VocoPro unit

The UHF-18 DIAMOND can be installed in a compatible VocoPro unit, such as the

SOUNDMAN, DVD-SOUNDMAN, CHAMPION-RV and HERO-RV.

To install the UHF-18 DIAMOND:

1. Turn off the unit and unplug it from the power source.

2. Unscrew the expansion port cover.

NOTE: The rear panel of your unit may differ from what is

shown in the illustration, but the installation procedure will be

the same.

3. Pull the expansion port cover from the expansion port, and

disconnect the connection cable.

NOTE: Do not let the cable fall back into the unit.

It may be necessary to temporarily secure the cable to the unit

with a piece of tape to prevent the cable from falling back into

the unit.

4. Attach the connection cable to the UHF-18 DIAMOND receiver.

NOTE: The 1/4” jack and DC power input are not used when

the UHF-18 DIAMOND is used as a plug-in module.

5. Carefully slide the UHF-18 DIAMOND receiver into the

expansion port, and secure it in place using the two screws.