User's Manual

10
11
Getting Connected
Using the UHF-18 DIAMOND as a stand-alone unit
The UHF-18 DIAMOND can be used with any device that has a 1/4” mic input.
To connect the UHF-18 DIAMOND receiver:
1. Use a 1/4” patch cable to connect the UHF-18 DIAMOND receiver mic out to the 1/4” mic input on you mixer or
other device.
2. Connect the power adapter cable to the DC power input of the UHF-18 DIAMOND receiver and plug the adapter into
the power source. A surge protector is recommended.
MIC 1 MIC 2 MIC 3 DELAY ECHO REPEAT BASS MID TREB BASS BALANCE MID TREB
MIC VOLUME MIC INPUT MIC EFFECT MIC EQ MUSIC EQ
This connection is not used
when the UHF-18 DIAMOND
is used as a stand-alone unit.
Mixing Amplifier with 1/4” mic input
(VocoPro DA-3808 shown)
Surge Protector
NOTE: Use the power adapter only when using the UHF-18 DIAMOND as a stand alone unit as shown above. Connecting
the power adapter when using the UHF-18 DIAMOND as a plug-in module may result in damage to the UHF-18 DIAMOND.