Operating instructions

Page 14 | TR004 COLONIAL™ TR004M | 11102010.0
SERVICE HINTS
house or tree falls on top of the chimney like water
over a dam, beating down the smoke. The top of
the chimney should be at least three (3) feet above
the roof and be at least two (2) feet higher than any
point of the roof within ten (10) feet.
GLASS CARE
The following usage and safety tips should be ob-
served:
1. Inspect the glass regularly for cracks and breaks.
If you detect a crack or break, extinguish the fire
immediately and contact the manufacturer for a
replacement.
2. Do not slam the door or otherwise impact the glass.
When closing doors, make sure that logs or other
objects do not protrude to impact the glass.
3. Do not build fires against (or that might fall against)
the glass.
4. Do not clean the glass with materials that may
scratch (or otherwise damage) the glass. Scratches
on the glass can develop into cracks or breaks dur-
ing operation.
5. Never attempt to clean the glass while the unit is
hot. If deposits are not very heavy, normal glass
cleaners are adequate using a soft, non-abrasive
cleaning pad. Heavier deposits may be removed
with oven cleaners.
6. Never put substances which can ignite explosively
in the unit. Even small explosions in confined areas
can blow out the glass.
Gasket and Glass cleaning products are available at
local retail home centers. Manufacturers of cleaning
products for wood stoves include, A.W. Perkins Co.
(www.awperkins.com) or Rutland Products (www.
rutland.com).
GLASS REPLACEMENT
CAUTION: Replace glass ONLY with 5mm High
Temperature ceramic glass of the proper size.
DO NOT USE tempered glass or double thick-
ness window glass!
Glass Replacement Procedure:
1. Ensure appliance is not in operation and is thor-
oughly cooled.
2. Remove screw and glass clip. (See parts list and
diagram.)
3. Lift glass out from glass clip.
4. Remove old gasket and clean glass.
5. Replace new gasket starting at the bottom of glass
working along edges, being sure to center gasket
channel on glass.
6. Trim to length and butt ends together.
7. Replace glass into door, being sure not to over-
tighten screw and clip.
After extensive use, the gasket material which provides
glass and door seal may lose it’s resiliency and will
need to be replaced. Inspect glass and door gaskets
periodically to ensure proper seal; if gaskets become
frayed or worn, replace immediately.
Door Gasket Replacement Procedure:
1. Ensure appliance is not in operation and is
thoroughly cooled.
2. Remove old door gasket and clean channel.
3. Using an approved, high temperature gasket
cement, apply a thin coat in bottom of channel.
4. Starting at hinge side of door, work gasket into
channel around door unit, end butt and trim to
length.
5. Close door and allow three to four hours for cement
to set before firing appliance.