User's Guide

VOKKERO ELITE FCC | User Guide V1.1
26 / 28
EN
6.3. CONFIGURATOR
6.3.1. Backlight
Slide the cursor from left and right to decrease and increase, respectively, thescreen lighting.
6.3.2. Screen calibration
The configurator touchscreen is already calibrated in the factory; you can however calibrate your own touchscreen if you note a significant
change in screen detection.
To do this, carry out the following 5 steps:
Select each angle with the yellow pointer, then select the circle at the middle of the screen.
6.3.3. Locking
Allows you to block access to the configurator using a PIN code.
In Lock mode, only the «Quick Configuration” menu is available. You can only access the other settings after validating the PIN code.
Note: The PIN code consists of 1 to 6 digits
Once the lock has been activated, the PIN code can be modified or desactivated (see screen below showing the options available in the «Lock»
menu, once the lock has been activated).
6.3.4. Versions / Software
Resetting the configurator functions
In order to put the configurator back in factory mode (and thus cancel all the configuration changes made previously), do the following:
1. Unplug the configurator
2. Reconnect the configurator
3. When the configurator is switched on, on the first home screen, consisting of the «VOKKERO®» logo: press the 2nd «O” of VOKKERO
4. Then you can restore the default settings of the configurator
5. Confirm
6. The configurator parameters have been reseted