User manual

WWW.VOICEINTEROP.COM
8000 N. Federal Highway, Suite 100, Boca Raton, FL, 33487 V: +1 561.939.3300

AM360a User Manual
revised 2009.02.16 for
Hardware Rev. A
Firmware Version 1.00.23
Speaker Volume, Microphone Level, Line Out Level, and Line In Level display the current
setting of their respective audio levels. These can be changed in the Module Configuration
screen.
Talk Mode when Active indicates that voice packets are being streamed to the LAN
port. This can be triggered on demand by the Microphone PTT switch, I/O 1 input, VOX
activation, or full time by checking either the Microphone Continuous Stream or Line In
Continuous Stream checkboxes.
Listen Mode when Active indicates that the LAN port is receiving voice packets addressed
to this unit.
I/O  indicates the state of this digital input line on the rear connector. When Hi it is idle and
no RTP voice packets are streamed to the network. When it shows Low it is active and RTP
packets will be streamed from the Line Input to the network.
I/O  indicates the state of this digital output line on the rear connector. When Hi it is idle.
When it shows Low it is active, indicating that audio is available on the Line Output jack.
This might be used to drive a mic precedence (mute) input on a PA amplifier or to trigger a
circuit that activates indicator lamps to draw attention to an announcement.
Microphone PTT shows the state of the PTT switch on the Microphone input.
Microphone Hook is not used.