User manual

WWW.VOICEINTEROP.COM
8000 N. Federal Highway, Suite 100, Boca Raton, FL, 33487 V: +1 561.939.3300

AM360a User Manual
revised 2009.02.16 for
Hardware Rev. A
Firmware Version 1.00.23
Channels (WaVe 4)
Log in to WAVE. Click Media Servers -> Interfaces, then click the Add Interface button.
From the dropdown listbox select VoiceInterop AM and click the Next button. In the
Name field type a meaningful name. Tab to the Description field and type a meaningful
description.
In the Gateway IP Address field type the management address of the AM360 that will be
associated with this endpoint. In the RTP Remote IP address field type the exact same
multicast group address that you configured into the AM360 above. Tab over to the RTP
Remote Port field and type the exact same port number that you configured into the AM360
above. In the RTP Local IP address field type the exact same multicast group address that
you configured into the AM360 above. Tab over to the RTP Local Port field and type the
exact same port number that you configured into the AM360 above.
In the Codec listbox select the same codec as was selected in the AM360 above; if you
choose GSM then set the Scale to .
Click the Save button to save your changes. If there are no other configuration changes to
be entered, click the button Commit Changes.
sessions (WaVe 3)
If you already have the desired standard user channel configured, click Sessions -> Sessions,
then click the Add Session button.
In the dropdown listbox select Advanced, then click the Next button.
Type a meaningful name in the Name field. Tab to the Description field and type a
meaningful name. Select the desired group from the Group listbox and click the Save
button to reveal the full Session configuration screen.
Leave the Conference ID / DN field blank and clear the checkbox labeled Treat as the Dial-In
DN. Click the Add Servers button and select the desired media servers that will handle this
session. Click the Add Participant button and add the multicast trunk channel from above
and the desired standard user channel that will be bridged with this AM360 device.
Click the button Save and Commit changes. Your AudioMate 360 device is now bridged
via multicast with the desired WAVE Standard channel. Test the configuration using an
AudioMate Communicator soft console.
sessions (WaVe 4)
To configure a session in WAVE version 4, proceed as directed for WAVE 3 installations. The
only difference comes when adding participants to the session. After adding the standard
user channel as indicated for WAVE 3, click the Add Participant button again. In the
dropdown listbox select VoiceInterop AM, then click the Next button. Select the desired
AM360 by checking the box next to it, then click the Add Selected Participants button.
Unicast Conguration
AM
Open a web browser and point it to the management IP address of the AudioMate
360 device to be configured. Log in with user admin and password password or the
credentials that you have configured.
WAVE 4
The AudioMate 360 is
integrated into WAVE 4 as a
media server interface. Add
an AM360 to a session as an
interface.
WAVE 4
The AudioMate 360 is
integrated into WAVE 4 as a
media server interface. Add
an AM360 to a session as an
interface.