User manual

WWW.VOICEINTEROP.COM
8000 N. Federal Highway, Suite 100, Boca Raton, FL, 33487 V: +1 561.939.3300

AM360a User Manual
revised 2009.02.16 for
Hardware Rev. A
Firmware Version 1.00.23
Under Configuration click Global.
In the field RTP Remote IP type the unicast address of the target media server. For RTP
Remote Port and RTP Local Port type a port number between 16384 and 65534; both
fields should be identical numbers. For Codec select G.u; if your network will not support
about 100kbps streams then select GSM. Click the button Update Configuration to save
your changes.
WAVE
Channels (WaVe 3)
Log in to WAVE. Click Channels -> Channels, then click the Add Channel button. From the
dropdown listbox select Point-to-point Trunk, then click the Next button. In the Name field
type a meaningful name. Tab to the Description field and type a meaningful description.
Select a group from the Group listbox.
In the Trunk Side A IP address field type the IP address of the target media server. In the
Port field type the same port number that you configured into the AM360 above.
In the Trunk Side B IP address field type the IP address of the AM360 above. Tab over to the
Port field and type the exact same port number that you configured into the AM360 above.
In the Codec listbox select the same codec as was selected in the AM360 above; if you
choose GSM then set the Scale to 1. All remaining settings may be left at their defaults.
Click the Save button to save your changes. If there are no other configuration changes to
be entered, click the button Commit Changes; else, configure Sessions as above.
Channels (WaVe 4)
Log in to WAVE. Click Media Servers -> Interfaces, then click the Add Interface button.
From the dropdown listbox select VoiceInterop AM and click the Next button. In the
Name field type a meaningful name. Tab to the Description field and type a meaningful
description.
In the Gateway IP Address field type the management address of the AM360 that will be
associated with this endpoint. In the RTP Remote IP address field type the management IP
address of the AM360 above. Tab over to the RTP Remote Port field and type the exact same
port number that you configured into the AM360’s field labeled ‘RTP Local Port’. Leave the
RTP Local IP address field blank to use the binding IP address of the target media server. Tab
over to the RTP Local Port field and type the exact same port number that you configured
into the AM360’s field labeled ‘RTP Remote Port’.
In the Codec listbox select the same codec as was selected in the AM360 above; if you
choose GSM then set the Scale to .
Click the Save button to save your changes. If there are no other configuration changes to
be entered, click the button Commit Changes.
The session that bridges these unicast channels are configured in a procedure similar to
bridging multicast channels in WAVE version 4.
Remote vs Local
The terms Remote and Local
are relative to the device that
you are configuring. In WAVE,
the media server is the Local
address while Remote refers
to the AudioMate 360 unit.
Remote vs Local
The terms Remote and Local
are relative to the device that
you are configuring. In WAVE,
the media server is the Local
address while Remote refers
to the AudioMate 360 unit.