User manual

WWW.VOICEINTEROP.COM
8000 N. Federal Highway, Suite 100, Boca Raton, FL, 33487 V: +1 561.939.3300

AM360a User Manual
revised 2009.02.16 for
Hardware Rev. A
Firmware Version 1.00.23
RTP Remote IP is the multicast group or unicast address of the other end. The Class D
multicast range lies between 225.0.0.0 and 239.255.255.255 with numerous
restrictions and considerations. A unicast address should fall within your LAN’s private IP
address space. Consult Appendix B for more information on multicast address assignment.
RTP Remote Port is the IP port number assigned to this channel. This should be an even
number between 16384 and 65534.
RTP Local Port should be identical to the RTP Remote Port number.
Codec should be set to Gu for most applications. Other choices are Ga for G.711 A-law,
and GSM for GSM 6.1 full rate.
When you are satisfied with all the settings that appear on the Global Configuration page,
be sure to click on the button labeled Update Configuration at the top of the page. Your
new settings take effect immediately. To revert back to the previously saved values while
editing click the button labeled Reset Values at the top of the page.
Personality Module Conguration
In the menu pane on the left, locate the Configuration heading and click the link Module
under it. The screen labeled AMa (Analog) Config should appear in the right pane.
Speaker Volume displays the current setting of the Speaker output level. To set this Volume
level electronically, type in a value between 0 and 15 and click Update Configuration.
Microphone Level displays the current setting of the Microphone input level. To set this
level electronically, type in a value between 0 and 15 and click Update Configuration.
Microphone Continuous Stream forces the AM360a to stream audio to the network
continuously, regardless of the PTT input of the microphone. Check this box to force
continuous streaming; clear this checkbox to require the PTT microphone digital input to
control streaming to the network.
RTP Remote IP
is the address of the device
at the other end of the
link, not the device you
are configuring. It could
be a WAVE media server or
another AudioMate 360.
RTP Remote IP
is the address of the device
at the other end of the
link, not the device you
are configuring. It could
be a WAVE media server or
another AudioMate 360.
Appendix B
has more detail on selecting
multicast addresses with
pointers to reference sources.
Appendix B
has more detail on selecting
multicast addresses with
pointers to reference sources.