User manual

WWW.VOICEINTEROP.COM
8000 N. Federal Highway, Suite 100, Boca Raton, FL, 33487 V: +1 561.939.3300

AM360a User Manual
revised 2009.02.16 for
Hardware Rev. A
Firmware Version 1.00.23
Line Out Level displays the current setting of the Line Output level. To set this level
electronically, type in a value between 0 and 15 and click Update Configuration.
Line In Level displays the current setting of the Line Input level. To set this level
electronically, type in a value between 0 and 15 and click Update Configuration.
Line In Continuous Stream forces the AM360a to stream audio to the network continuously,
regardless of the state of the I/O 1 input on the rear. Check this box to force continuous
streaming; clear this checkbox to require the I/O 1 on the rear connector to control
streaming to the network.
VOX Threshold sets the audio level above which the AM360a will begin streaming audio
to the network without requiring a hardware digital signal (COS or I/O 1) to go active.
Type a number between 0 and 50 that provides the desired operation. A value of 0 is the
most sensitive setting while 50 is the least sensitive. NOTE that VOX operation will prevent
proper operation of channel patches on soft console systems.
VOX Delay enables the VOX feature and sets the hang time during which the AM360a will
continue to stream RTP packets to the network after the audio level falls below the VOX
Threshold level. Set this to a value between 0.1 and 25.5 seconds that eliminates choppy
operation with the type of audio that you are streaming. When this value is set to 0 (zero)
the VOX feature will be disabled.
When you are satisfied with all the settings that appear on the Module Configuration page,
be sure to click on the button labeled Update Configuration at the top of the page. Your
new settings take effect immediately. To revert back to the previously saved values while
editing click the button labeled Reset Values at the top of the page.