Owner`s manual
to clear all programming, press and hold the
two outside buttons and release when the
indicator light begins to flash (approximately
20 seconds).
ROLLING CODE PROGRAM-
MING
Rolling code garage door openers (or other
rolling code devices) which are “code pro-
tected” and manufactured after 1996, may be
determined by the following.
A. Reference the garage door opener Owner’s
Manual for verification.
B. The hand-held transmitter appears to pro-
gram the HomeLinkT Universal Trans-
ceiver but does not activate the garage
door.
C. Press and hold the trained HomeLinkT
button. If the garage door opener has the
rolling code feature, the HomeLinkT indi-
cator light will flash rapidly, then remains
on after 2 seconds.
To program the HomeLinkT Universal Trans-
ceiver to a garage door opener with the rolling
code feature, follow these instructions after
completing the “Programming HomeLinkT”
(the aid of a second person may make the
following procedures quicker and easier).
1. Locate the training button on the garage
door opener motor unit. Exact location and
color of the button may vary by garage
door opener brand. If there is difficulty
locating the training button, reference the
garage door opener Owner’s Manual.
2. Press the training button on the garage
door opener motor unit (which may acti-
vate a training light).
NOTE:
Following step 2, there are 30 sec-
onds in which to initiate step 3.
3. Firmly press and release the programmed
HomeLinkT button. Press and release the
HomeLinkT button a second time to com-
plete the training process. (Some garage
door openers may require you to do this
procedure a third time to complete the
training.)
The garage door opener should now recognize
the HomeLinkT Universal Transceiver and
activate when the HomeLinkT button is
pressed. The remaining two buttons may now
be programmed (if not yet programmed, fol-
low steps 2 through 4 in the “Programming
HomeLinkT” procedures earlier in this sec-
tion).
REPROGRAMMING A SINGLE
HomeLink
T
BUTTON
To reprogram an HomeLinkT Universal Trans-
ceiver button, complete the following.
1. Press and hold the desired HomeLinkT
button. Do not release the button until
step 4 has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
INSTRUMENTS AND CONTROLS
2-50
Z 02.2.7/JR50-D X