Owner`s manual

O When the key is inserted into the ignition
switch.
O When the driver’s door is closed with the
key turned to ACC or LOCK.
O When the key is turned to ON.
Procedure for storing memory
Two positions can be stored in the automatic
drive positioner memory. Follow these pro-
cedures to use the memory system.
1. Set the automatic transmission selector
lever to the P (Park) position.
2. Turn the ignition ON.
3. Adjust the driver’s seat and steering col-
umn to the desired positions by manually
operating each adjusting switch. For addi-
tional information, see “Seats” in the “1.
Seats, restraints and supplemental air bag
systems” section and “Steering wheel”
earlier in this section.
During this step, do not turn the ignition to
any positions other than ON.
4. Push the SET switch and, within 5 sec-
onds, push the memory switch 1 or 2 fully
for at least 1 second.
The indicator light for the pushed memory
switch will come on and stay on for
approximately 5 seconds after pushing the
switch. After the indicator light goes off,
the selected positions are stored in the
selected memory (1 or 2).
If memory is stored in the same memory
switch, the previous memory will be de-
leted.
Confirming memory storage
O Turn the ignition ON and push the SET
switch. If the main memory has not been
stored, the indicator light will come on for
approximately 0.5 seconds. When the
memory has stored the position, the indi-
cator light will stay on for approximately 5
seconds.
O If the battery cable is disconnected, or if
the fuse blows, the memory will be can-
celed. In such a case, reset the desired
positions using the following procedures.
1. Open and close the driver’s door more
than two times with the ignition key in the
LOCK position.
2. Reset the desired position using the pre-
vious procedure.
SIR0135
PRE-DRIVING CHECKS AND ADJUSTMENTS
3-18
Z 01.9.13/JR50-D X