Owner`s manual

Selecting the memorized position
1. Set the automatic transmission selector
lever to the P (Park) position.
2. Turn the ignition ON.
3. Push the memory switch 1 or 2 fully for at
least 1 second.
The driver’s seat will move to the memo-
rized position with the indicator light flash-
ing, and then the light will stay on for
approximately 5 seconds.
When the memory switch 1 or 2 is pushed
with the driver’s door open and then the key
inserted into the ignition switch within ap-
proximately 1 minute, the driver’s seat will
move to the memorized position.
System operation
The automatic drive positioner system will not
work or will stop operating under the follow-
ing conditions:
O when the vehicle speed is above 4 MPH (7
km/h).
O when any two or more of the memory
switches are simultaneously pushed while
the automatic drive positioner is operating.
O when the adjusting switch for the driver’s
seat is turned on while the automatic drive
positioner is operating.
O when the cancel switch located on the
instrument panel is pushed to cancel.
O when the memory switch 1 or 2 is not
pushed for at least 1 second.
O when the seat has been already moved to
the memorized position.
O when no seat position is stored in the
memory switch.
CANCEL SWITCH
When the CANCEL side of the switch is
pushed, the automatic drive positioner system
will not function.
When the AUTO side of the switch is pushed,
the system will function.
SIR0136
PRE-DRIVING CHECKS AND ADJUSTMENTS
3-19
Z 01.9.13/JR50-D X