Owner`s manual

ratories Licensing Corporation.
Metal or chrome tape usage :
The cassette player will be automatically set to
high performance play when playing a metal
or chrome cassette tape.
FM-AM radio operation
FM/AM band select :
Pushing the FM/AM band select button will
change the band as follows:
AM → FM1 → FM2 → AM
When FM/AM band select button is pushed
while the ignition switch is in the ACC or ON,
the radio will come on at the station last
played.
The last station played will also come on when
the power knob is turned to ON.
If a compact disc or tape is playing when the
FM/AM band select button is turned to ON,
the compact disc or tape will automatically be
turned off and the last radio station played will
come on.
The FM stereo indicator ST will glow during
FM stereo reception. When the stereo broad-
cast signal is weak, the radio will automati-
cally change from stereo to monaural recep-
tion.
TUNE (Tuning) :
WARNING
The radio should not be tuned while
driving so full attention may be given
to vehicle operation.
Use these buttons for manual tuning. To move
quickly through the channels, hold either of
the TUNE buttons down for more than 0.5
seconds.
SEEK tuning :
Push the SEEK button
or ,to
tune from high to low or low to high frequen-
cies and stops at the next broadcasting
station.
SCAN tuning :
Push the SCAN tuning button to tune from low
to high frequencies and stops at each broad-
casting station for 5 seconds. Pushing the
button again during this 5 seconds period will
stop SCAN tuning and the radio will remain
tuned to that station.
If the SCAN tuning button is not pushed
within 5 seconds, SCAN tuning moves to the
next station.
Station memory operations :
Twelve stations can be set for the FM band
(six for FM1, six for FM2) and six stations can
be set for the AM band.
1. Tune to the desired station using the
HEATER, AIR CONDITIONER AND AUDIO SYSTEMS
4-17
Z 01.9.13/JR50-D X