Owner`s manual

Jacking up and removing wheel
Carefully read the following instruc-
tions.
1. Put the adapter stored in the tool bag on
the jack when jacking up the front side.
Do not use the jack adapter for the
rear.
2. Place the jack directly under the jack-up
point.
The jack should be used on level
firm ground.
3. Loosen each wheel nut one or two turns by
turning counterclockwise with the wheel
nut wrench.
Do not remove the wheel nuts until the
tire is off the ground.
4. Carefully raise the vehicle until the tire
clears the ground. To lift the vehicle,
securely hold the jack lever and rod with
both hands as shown above. Remove the
wheel nuts, and then remove the wheel. Do
not remove the brake drum with the wheel.
WARNING
O Never get under the vehicle while
it is supported only by the jack.
O Use the jack provided with your
vehicle. Do not use the jack pro-
vided with your vehicle on other
vehicles.
The jack is designed only for lift-
ing your vehicle during a tire
change.
O Use the correct jack up points;
never use any other part of the
vehicle for jack support.
O Never jack up the vehicle more
than necessary.
SIE0024
IN CASE OF EMERGENCY
5-5
Z 96.12.20/ X