Owner`s manual

CHANGING ENGINE OIL
1. Park the vehicle on a level surface and
apply the parking brake.
2. Run the engine until it reaches operating
temperature, and then turn it off.
3. Place a large drain pan under the drain
plug.
4. Remove the oil filler cap.
5. Remove the drain plug with a wrench and
completely drain the oil.
If oil filter is to be changed, remove and
replace it at this time. See ‘‘Changing the
oil filter’’.
CAUTION
Be careful not to burn yourself. The
engine oil will be hot.
Waste oil must be disposed of prop-
erly. Check your local regulations.
6. Clean and re-install the drain plug and
washer. Tighten the drain plug with a
wrench.
Drain plug tightening torque:
22 to 29 ft-lb
(29 to 39 Nzm)
Do not use excessive force.
7. Refill the engine with recommended oil
and install the cap securely.
See the ‘‘Technical information’’ section for
oil type and refill capacity.
8. Start the engine.
Check for leakage around the drain plug.
Correct as required.
9. Turn the engine off and wait several
minutes. Check the oil level. Add engine
oil if necessary.
10.Dispose of waste oil in the proper manner.
WARNING
O Prolonged and repeated contact
with used engine oil may cause
skin cancer.
O Try to avoid direct skin contact
with used oil. If skin contact is
made, wash thoroughly with soap
or hand cleaner as soon as
SID0090
DO-IT-YOURSELF
7-9
Z 96.12.20/ X