Owner`s manual

The clearance, tail, license plate and instru-
ment lights will come on.
Turn the switch to the ‘‘
’’ position:
Headlights will come on and all the other
lights remain on.
Daytime running light system
(For Canada)
The headlights automatically illuminate at a
reduced intensity when the engine is started
with the parking brake released. The daytime
running lights operate with the headlight
switch in the ‘‘OFF’’ position or in the ‘‘
’’
position. Turn the headlight switch to the
‘‘
’’ position for full illumination when
driving at night.
If the parking brake is applied before the
engine is started, the daytime running lights
do not illuminate. The daytime running lights
illuminate once the parking brake is released.
The daytime running lights will remain on
until the ignition switch is turned off.
WARNING
When the daytime running light sys-
tem is active, tail lights on your
vehicle will not be on. It is necessary
at dusk to turn on your headlights.
Failure to do so could cause an
accident injuring yourself and oth-
ers.
To select the high beam, push the lever for-
ward. Pull it back to select the low beam.
Passing signal
Pulling the lever toward you will flash the
headlight high beam.
Turn signal
Move the lever up or down to signal the
turning direction. When the turn is completed,
the turn signals cancel automatically.
Lane change signal
To indicate a lane change, move the lever up
SII0120
SII0121
INSTRUMENTS AND CONTROLS
1-20
Z 96.12.20/ X