Owner`s manual

PROGRAMMING THE
HomeLink
T TRANSMITTER
WARNING
During the programming procedure
your garage door or security gate
will open and close (if the transmit-
ter is within range). Make sure that
people or objects are clear of the
garage door, gate, etc. that you are
programming.
Your vehicle’s engine should be
turned off while programming
your transmitter. The Integrated
HomeLink
T Transmitter may not
work with older garage door openers
that do not meet current Federal
Consumer Safety Standards.
1. Test the Integrated HomeLinkT Transmit-
ter by pressing any button. The red indi-
cator light should come on. If you have
previously programmed a button proceed
to step 3.
2. Clear all channels on the Integrated
HomeLinkT Transmitter by holding down
both outside buttons (#1 & #3) until the
red light begins to flash rapidly (approxi-
mately 20 seconds). Then release both
buttons.
3. Select which of the three Integrated
HomeLinkT Transmitter buttons you want
to program.
4. Hold your hand-held transmitter against
the bottom surface of the Integrated
HomeLinkT Transmitter so that you can
still see the red indicator light.
5. Press the desired button until the red
indicator light flashes slowly. Do not
release the button. Continue holding and
press the hand-held transmitter button
through step 6.
6. Hold down both buttons until the
red indicator light on the Integrated
HomeLinkT Transmitter flashes rapidly
(This may take 1-90 seconds). Then re-
lease both buttons. The rapid flashing
means that the transmitter has been suc-
cessfully programmed to match your
SII0150
INSTRUMENTS AND CONTROLS
1-36
Z 96.12.20/ X